ok i had an electrical problem where i found two melted wires, and i had no blinkers, reverse lights, brake lights, or hazards. i fixed the problem (thank god) but now, since i have a haynes repair manual, its says that one of the wires that was melted was pin 6 for the ignition. well that wire is not even connected. i cut power to it to fix my electrical problem and it worked. andmy truck starts great and runs great. is this something i should be concerned about?

everything works, subs pound, all lights work, and it says its for the Acc.

 

if it aint broke dont fix it. like they say...drive it till it smokes and rattles...and then drive it faster!

 

k just needed to know cuz im makin a 1000 plus mile trip this weekend, and i dont want it to magically chort out due to that wire. but ive been drivin it 3 days since i fixed the electrical problem and no problems so far.

 

rent a prius...lol probably cheaper than gas in the dodge

 

im goin hunting with some buddies (my 22 b-day saturday!!) and we gunna be out in the woods on some dirt roads way up near canada

and its all hywy all the way there and i got , believe it or not, 283 miles (my rents house from here) and its only a half a tank, and im goin only 150 miles past that, so it wont be to bad with gas

throw on the cruise control and go