yeah i have used a penetrating oil twice tonight and will again in the morning then hammer and pull hammer then pull

 

you should only have to pull once to put tension on it. when you hit it hard enough it will just pop off. Dont be afraid of it, put alot of power into it.

 

you mean the pb blaster didn't work? thats a big surprise.
no you didn't. you used a lubricant.
pb blaster penetrates about as good as motor oil.

the tension and smacking with hammer should do the trick. and one thing that would help would be to get a penetrating fluid like CRC Knock'er Loose, Cyclo Breakaway or AeroKroil.
if you spray one of those on and go get some lunch then when you get back the pitman arm will be laying on the ground (maybe a bit of an exaggeration but they work quite well).

 

Quick note: there are tons of useful links in the DIY section at the top of the forum. For example, https://dodgeforum.com/forum/2nd-gen...m-removal.html

 

Then what would we have to do? LOL

 

Righty Tighty lefty losey ?

 

PB blaster is a gift from the gods, I have use it with more success than any other penetrating oil I have ever used. At work and on my personal stuff including an almost 30 year old jeep to break bolts that have not been out since the thing was built.

 

Not that it matters, to each his own you know. But what other brands have you tried?

 

obviously not one of ours.
probably liquid wrench and wd 40.

 

get a die grinder and cut tru the arms side (l) that should release some pressure and then hit with the hammer just be careful not to cut all the way to the shaft