Converting a unit bearing to spindles
Thread Starter
|
Professional
Joined: Jun 2007
Posts: 235
Likes: 0
From: Fond Du Lac, WI
Converting a unit bearing to spindles
I have seen kits for this on D60 fronts but what about the 44? Am I SOL? If spindles are not an option what is the best unit bearing you can think of and why?
For the record, I have a E-Locker front diff, factory cad, aftermarket stub shafts, bronze bushing u joints no needles, and 37" BFG KM2s. I do wheel it for work, nothing real rough, but can be sloppy in the rain and I pull a service trailer that can weight 8K lbs.
Anyone attempt cryo treating, I know a local metal manufacturer that I could sneak some parts through their process.
For the record, I have a E-Locker front diff, factory cad, aftermarket stub shafts, bronze bushing u joints no needles, and 37" BFG KM2s. I do wheel it for work, nothing real rough, but can be sloppy in the rain and I pull a service trailer that can weight 8K lbs.
Anyone attempt cryo treating, I know a local metal manufacturer that I could sneak some parts through their process.
Veteran
Joined: Aug 2007
Posts: 310
Likes: 3
From: Longview, WA
This is what you want then:
http://www.emsoffroad.com/store/inde...roducts_id=262
http://www.emsoffroad.com/store/inde...roducts_id=263
http://www.emsoffroad.com/store/inde...roducts_id=350
http://www.emsoffroad.com/store/inde...roducts_id=262
http://www.emsoffroad.com/store/inde...roducts_id=263
http://www.emsoffroad.com/store/inde...roducts_id=350
Last edited by armynurse; Jun 23, 2010 at 09:50 AM.