I found that I have the plenum leak and decided to mod the kegger. I decided to buy a spare so I could mod it and have it ready when I took the other one off. I got a kegger that was supposed to be non-egr, but they sent the wrong one. They have really good feedback (e-bay) so I should be OK if it's a problem. It also has the Holley TB and the divider inside it. The water temp sensor is mounted toward the center of the intake instead of toward the passenger side like my '01 and I don't know if the sensor will reach it. Does anybody know what would be involved with this? I know I'd need an egr block off plate and vacuum caps for all the extra ports on it.

 

Hey, i have a stock keg that is dirty from a bad plenum gasket, and one that is ported on my truck right now that is clean with fresh plenum gasket. I am about to switch out for M1 intake. both for sale, let me know

 

What mods were done to the kegger? How short were the runners cut, was the plenum filled, were the injector bosses opened up, does it have the Hughes plate? How much do you want for it shipped? Also, how much would you want for the stock one shipped?