the gap seems too big. i'll see if i can find a pic. is the gap from being ground off by the collar.

your shop is looking for a model number and bill of material. give me a minute and i'll find an example at dana.

 

found 2 places with conflicting numbers.
dana/spicer calls it the output shaft.
http://www2.dana.com/expertforms/depart.aspx?part=45770

http://www2.dana.com/expert/wc.dll?h...F_RAM~610786-1

dodge calls it the intermediate shaft, but its the same thing.
part number 40333 at quad.
http://quad4x4.com/Dodge%20Frt%20Axle&Steering.htm

not listed at riversidegear. they only list the 2500.

 

i have a question. you did the two door to four door kit. were would i find one of those cause i have wonted that since the day i got my dodge. and was it difficult to install?

 

Wow... First off, there is no kit. I was lucky enough to find a quad cab the same color and year as mine that had been wrecked. then it went kinda like this:





Today I hope to take the shaft and stuff and get another one ordered......