2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Vapor Canisters

Old Sep 18, 2010 | 05:01 PM
  #1  
SawFan862's Avatar
SawFan862
Thread Starter
|
Amateur
Joined: Apr 2010
Posts: 44
Likes: 0
From: Mass.
Default Vapor Canisters

Well about a month ago, I was out in the woods with a few friends going to a camp site, and had to climb a small rock wall (about a foot and a half tall), in the process, I broke both vapor canisters. I have gone to a few junkyards looking for some, but my question is, do single cabs and ext cabs have the same vapor canister setup?
 
Reply
Old Sep 18, 2010 | 10:17 PM
  #2  
dhvaughan's Avatar
dhvaughan
Hall Of Fame
Joined: Jul 2006
Posts: 12,204
Likes: 10
From: Gainesville, Ga.
Default

i think they'd be the same. did you pick up your pieces, and can you get a measurement on them to compare with at the junkyard. if you want a measurement just ask.
 
Reply
Old Sep 19, 2010 | 12:10 AM
  #3  
SawFan862's Avatar
SawFan862
Thread Starter
|
Amateur
Joined: Apr 2010
Posts: 44
Likes: 0
From: Mass.
Default

well i have a round and square canister, but all ive seen is sigle cabs with round canisters that are different
 
Reply
Old Sep 19, 2010 | 08:48 AM
  #4  
95RAM360's Avatar
95RAM360
Grand Champion
Joined: Aug 2009
Posts: 5,971
Likes: 45
From: MAINE
Default

off-topic....


where abouts in Mass? i go mudding in wareham in myles standish
 
Reply
Old Sep 19, 2010 | 10:17 AM
  #5  
SawFan862's Avatar
SawFan862
Thread Starter
|
Amateur
Joined: Apr 2010
Posts: 44
Likes: 0
From: Mass.
Default

Oh well that day I was in my friends land up in pittsfeild, it really wasn't muddin, lots of narrow trails and stuff though. I like going to hawley state forest to wheel now, except last time we ended up ripping a tranny cross member off a grand Cherokee.
 
Reply


Thread Tools
Search this Thread

All times are GMT -4. The time now is 10:09 PM.