DodgeForum.com

2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Wont start...Please help

Thread Tools
 
Search this Thread
 
Old Oct 3, 2010 | 04:12 PM
Share
  #1  
bobracing32's Avatar
bobracing32
Thread Starter
|
Rookie
Joined: Aug 2010
Posts: 56
Likes: 0
Default Wont start...Please help
we replaced the trans in my 318 and pinched off the crank sensor wire. I got a new sensor and it wont start now. I was just wondering if anyone else knew something i dont or what to try thanks.
 
Reply
0
Old Oct 3, 2010 | 04:27 PM
Share
  #2  
zman17's Avatar
zman17
Retired Moderator - RIP
Joined: May 2008
Posts: 18,729
Likes: 17
From: NH
Default
Did you check all the fuses and relays? Check for codes too. And if you bought a cheap sensor it could be a defect. Also, you should make sure the new one is the same length as the old one.
 
Reply
0
Old Oct 3, 2010 | 09:15 PM
Share
  #3  
bobracing32's Avatar
bobracing32
Thread Starter
|
Rookie
Joined: Aug 2010
Posts: 56
Likes: 0
Default
Yes its the same length it was 75 bucks its a good sensor, i checked all the fuses. Which relays should i check? Im a diesel guy, i know nothing about these gas motors. Thanks for you help so far.
 
Reply
0
Back to Subforum
2nd Gen Ram Tech
View Next Unread
More herculiner




Advanced Search
Reply Closed Thread Share
Forum Jump

All times are GMT -4. The time now is 06:29 AM.