DodgeForum.com

2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Camber help

Thread Tools
 
Search this Thread
 
Old Oct 20, 2010 | 03:37 PM
Share
  #1  
tyler50_50's Avatar
tyler50_50
Thread Starter
|
Registered User
Joined: Dec 2009
Posts: 5
Likes: 0
From: Florida
Default Camber help
The camber on my 01 1500 2wd is really off. It's wearing my tires really bad. Can I adjust it myself?
 
Reply
0
Old Oct 20, 2010 | 04:16 PM
Share
  #2  
zman17's Avatar
zman17
Retired Moderator - RIP
Joined: May 2008
Posts: 18,729
Likes: 17
From: NH
Default
Get an alignment.
 
Reply
0
Old Oct 20, 2010 | 06:08 PM
Share
  #3  
aim4squirrels's Avatar
aim4squirrels
Legend
Joined: Jul 2007
Posts: 7,843
Likes: 13
From: DFW, Texas
Default
Camber is not adjustable except by offset ball joint. You have another problem.
 
Reply
0
Old Oct 20, 2010 | 06:15 PM
Share
  #4  
zman17's Avatar
zman17
Retired Moderator - RIP
Joined: May 2008
Posts: 18,729
Likes: 17
From: NH
Default
Even a 2wd?
 
Reply
0
Old Oct 20, 2010 | 07:36 PM
Share
  #5  
aim4squirrels's Avatar
aim4squirrels
Legend
Joined: Jul 2007
Posts: 7,843
Likes: 13
From: DFW, Texas
Default
Oops, missed that, sorry! IFS camber is adjustable.

CAMBER: Move the forward position of the pivot
bar in or out. This will change the camber angle significantly
and caster angle only slightly. The camber
angle should be adjusted as close as possible to the
preferred service specification. After adjustment
is made tighten pivot bar nuts to specifications.
 
Reply
0
Back to Subforum
2nd Gen Ram Tech
View Next Unread
Alrighty Then Tranny Issues




Advanced Search
Reply Closed Thread Share
Forum Jump

All times are GMT -4. The time now is 11:51 PM.