DodgeForum.com

2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Adding cruise control to a factory non-cruise

Thread Tools
 
Search this Thread
 
Old Feb 17, 2011 | 08:52 PM
Share
  #1  
fin reaper's Avatar
fin reaper
Thread Starter
|
Rookie
Joined: Dec 2010
Posts: 50
Likes: 0
Default Adding cruise control to a factory non-cruise
96 ram 1500 5.2 manual

I'm swapping the above engine/harness/PCM into my Wrangler. I don't know if it had factory cruise on the donor truck, but the wires for cruise in the harness are there.

Are all PCM's programmed to handle cruise if I get the vacuum solenoid, brake switch setup and cruise switch.
 
Reply
0
Old Feb 17, 2011 | 11:58 PM
Share
  #2  
99dodge318's Avatar
99dodge318
Record Breaker
Joined: Mar 2010
Posts: 1,169
Likes: 0
From: Texas
Default
yeah i would go to a junk yard a remove everything that controls the cruise. and just plug and play!
 
Reply
0
Old Feb 18, 2011 | 10:06 PM
Share
  #3  
fin reaper's Avatar
fin reaper
Thread Starter
|
Rookie
Joined: Dec 2010
Posts: 50
Likes: 0
Default
Thanks, I plan to. I just didn't know if all PCMs came pre-programmed cruise ready.
 
Reply
0
Old Feb 18, 2011 | 10:45 PM
Share
  #4  
89newporker's Avatar
89newporker
Registered User
Joined: Feb 2011
Posts: 19
Likes: 0
Default
It's all plug in, the one thing CHRYSLER did get right LOL
 
Reply
0
Back to Subforum
2nd Gen Ram Tech
View Next Unread
99 Ram 1500 5.9l, is it dead yet?




Advanced Search
Reply Closed Thread Share
Forum Jump

All times are GMT -4. The time now is 07:23 PM.