When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
1ve got a 98 ram 1500 swapped out the front axle to a 95 and put 1 ton steering on it... problem is, is there is no steering stabilizer mount on the axle? is there something im missing? ive looked all over. i know i need the steering stabilizer cause with out it i will prolly have "death wobble". any help would be greatful. I know i can weld a bracket, but im not the best welder, just wondering if there is a way to by pass this problem without welding. thanks
just went out and looked again and the only idea I can come up with is putting the steering stabilizer on the outside bracket of the track bar, and getting a bigger bolt to go through both the stabilizer and the track bar... Would this work?
Some years they only had like a clamp assembly on the drag link. And in no way would NOT having a bad stabilizer cause "death wobble". Make sure all steering and suspension components are good. Trac bar comes to mind.
thanks, i know in the jeep having a bad stabilizer caused "death wobble"... I wasnt for sure if dodge would act the same... I think im just goin to cut off the mounting bracket off the 98 and have my buddy weld it on the bottom of the 95 axle.
so cut off the old bracket and my bud welded it to the new axle, took it for a test drive and everything seems to be ok. def needs a alignment after installing the 1 ton steering. Im not sure on how to upload pics tho?
upload your pics to a hosting site like photobucket. then copy/paste the IMG code directly into the thread. photobucket will show you the IMG code under each pic that you upload, and allow you to copy it.