when i bought my truck i noticed the bumber sits on an angle higher in the front lower in the back i believe the guy who had it before me hit something is this easy to adjust..... how can i do it? thank you

 

very easy to adjust. get a can of PB-Blaster penetrating oil and spray liberally on all the bolts and let it soak for awhile (a couple of hours or a day or two). you'll need an 18mm deep well socket (i think), a cheater pipe or impact wrench. loosen everything up and just let it droop, then put a floor jack up under it and position everything nice and level and even and snug it back up, double check, then tighten it back up good.

i did my front and rear. prev owner was rough on them, pulling stuff with the bumpers.

 

ahhh good ol B-P works every time

 

I swear by that stuff

 

r u saying its better then the good old WD!!!!