That is amazing looking. If you are interested in selling your stock bumper, let me know. I would be interested.

 

Looks good!

 

that looks great! if i wasnt so worried about using my bumper i would do that. awesome!

 

Looks sharp! Glad to see there are more out there! I do like steel more, but I could only find the Lund fiberglass one at the time so I took it. Lol.

Are you lighting the license plate? If you havent found anything yet, Im using the Radiantz lighted frame right now:
http://www.radiantz.com/index1.html?c17.html&1
I had a few problems with a few of the LEDs burning out after a few hours of use, but Im on my 2nd replacement and its been doing fine.

If the lights burn out again, Im just going to switch to one of these:
http://www.amazon.com/Carriage-Works.../dp/B000BN82W4

 

Thanks. But mine came with a light kit.

 

Gotcha. That was the only thing that sucked about Lund.

 

Nice! Looks sharp!

Btw what part of PA do you live in? lol

 

That looks hot! I love how clean the lines are with the rollpan, if I ever figure out a good setup to keep my hitch I'll probably get one.

 

Now that's what I call a tight rear end.

 

If you remove the spare, you can weld a hitch right to the frame and be set. Where the frame and the bottom of the roll pan are, the receiver will be right below the license plate

This is going to be my winter project