So I've been browsing around and looking but no real difinitive answers or really good pics of how you guys mounted your efans. I have some ideas but just want ot see if theres anything better out there or were all pretty much on the same path. I've had all the pieces to throw this thing on and finally should have time this weekend so pics, doodles, and/or really good explainations would be greatly appreciated!

 

I just used self tapping screws that were included to go through the existing shroud into the shroud of the e-fan...

 

i used these....http://shop.advanceautoparts.com/web...061A____worked like a charm now getting them off you need to cut them....i hope you bought a new fan too....

 

Well I got my taurus fan for now. I saw your post earlier jay that your fan crapped out on you. I figure if it lasts for a little bit im only out $20 and I'll be wired for a replacement when the time comes. Oh and your link is down right now but i looked at your install thread earlier too and i think i know what you used. Zip tie kinda things right? Did they bend your fins or cause any damage from hanging on the rad. like that?

Any other ideas guys?

 

No it will not damge your radiator. I used those pull through zipties on my truck for the dual e-fan setup. Makes a secure position using 8 ties, wont be going no where.Less than 5 bucks at hardware store

 

there like 7.99 at advance im sure autozone or napa carries the like....but no damage done although cutting them off were a bitchhhhh when i needed to get off that junk fan....