I installed the 3" spindles (No Pic) I am running stock rims and what to mount my new interco ss-m16 295 70 17. Would i need to add a spacer or not , so they dont rub?

Thank

 

What spindles did you install? there are a few companies that make them. Anyway, you didnt list what rims you have, backspacing offset etc and what the spindles require. Pretty vague

 

Sorry 3" lift spindle from ebay and running stock 17x8 rims & going to mount 295 70 17 interco ss-m16 tires (33.5) Would i need to put a wheel spacer on the font end of the truck so they dont rubber?

Spec interco ss-m16

 

I think you will be fine. Not alot of people have installed the spindles yet so not too sure. Theres no point in getting a .5" spacer though, either a 1.5" to clear the studs or 1/4" are the options. You wont have enough stud length with a .5" spacer IMO.

I like the M16s kinda. Post some pics of the spindle lift and tell us about the install. There are a ton of people wanting to do it.