I'm Looking to find a Truck Bed cover that splits down the center and folds off the sides, I've seen a few pictures of this, and I saw one on a Rumble Bee version of my truck, it would be perfect for my uses. I'm looking to see If this is actually a mass produced product or if it is a custom build, and if it is not a custom, I'm looking for a location i may purchase one

 

"tannaeu cover" is what your looking for i believe searching this will yeild better results

 

Never seen or heard of such a design.

Mine folds up into the bed on a roller frame and folds to the front. The front 8" is not useable and you cannot have a full load within 2ft of the front and open up the cover. Other than that, it's great. Peragon is the name.
https://dodgeforum.com/forum/3rd-gen...ml#post2737860

 

http://4wheelonline.com/Diamondback_180_Covers.141459

All of the side access tonneau covers I found were in diamond plate aluminum, and they are extremely expensive. $1300-$1500.

 

http://gaylordslids.com/butterfly.php

Mopar used to carry a model with side wings over the front 1/3 or so and the back was typical rear open design. Don't know if they make it anymore. There's one called 4way cover if you don't need a split. It allows access from all sides but still one piece so not that practical if hauling anything. http://4waytonneaucover.com/