Double DIN Conversion Kit
#1
Double DIN Conversion Kit
After looking at my options for my 2007, you know, 200 bucks or more for a DD bezel and spending time and money on fabrication, I almost went for a single radio. I did more searching and found this>>>>
http://www.ebay.com/itm/272017188543?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT
It was actually very easy. The instruction were pretty simple. If you get one of these pay particular attention to the shaded areas to cut out. You have to take the center bar out (no big deal) but you also have to trim about 1/16 from both side edges. It took me all of 5 minutes to make the modification. The kit I bought came with the mounting hardware, wiring jumper and an ant. jumper. The face can be had for about 15 bucks by itself. Sorry I didn't photo the process, but I took me a month to find the time to even do it. I considered painting it after fitting and trimming, but decided not to bother.
The radio is a Kenwood DDX373BT I really, really like it BTW.
http://www.ebay.com/itm/272017188543?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT
It was actually very easy. The instruction were pretty simple. If you get one of these pay particular attention to the shaded areas to cut out. You have to take the center bar out (no big deal) but you also have to trim about 1/16 from both side edges. It took me all of 5 minutes to make the modification. The kit I bought came with the mounting hardware, wiring jumper and an ant. jumper. The face can be had for about 15 bucks by itself. Sorry I didn't photo the process, but I took me a month to find the time to even do it. I considered painting it after fitting and trimming, but decided not to bother.
The radio is a Kenwood DDX373BT I really, really like it BTW.
Last edited by TNtech; 05-18-2016 at 09:46 PM.