When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
I have a 2003 Dodge Ram 1500SLT 4x4. Was out all day Saturday truck drove around with no problems. Got up Sunday morning, started truck up put in reverse, transmission shifted into reverse but truck will not move!!!! Put truck into drive, no problems drives and shifts as should. Place the truck in reverse, tranmission shifts into reverse but truck will not move. I tried the built in code reader, and it shows no problem codes for transmission or rear end. I could use some advice on this one. This is my only vehicle. HELP!!!!!!
Did you check it the right way?? Engine warmed up? Cycle thru the gears? left in neutral with parking brake on? I know it sounds like a dumb question....
Some of the trannys are electronic controled. There may be something going on with the controler. Also unless you have over 70,000 miles that would be covered under the powertrain warrenty which is 7 years or 70,000 miles.