3rd Gen Ram Tech 2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Help with airbag light

Thread Tools
 
Search this Thread
 
Old Aug 8, 2008 | 10:18 PM
  #1  
dwhaye's Avatar
dwhaye
Thread Starter
|
Junior Member
Joined: Aug 2008
Posts: 2
Likes: 0
Default Help with airbag light

I recently purchased a Ram 1500 2003 from an auction. It had been wrecked at some point and fixed I am assuming because the airbag light was on. We sent the module off to be reset but it was sent back with an internal error and therefore had to purchase new. THe dealership said that the new module did not need to be VIN locked and all I had to do was plug it back in. Didn't work. The airbag light is still on. Can anyone help?
 
Reply
Old Aug 9, 2008 | 01:16 AM
  #2  
FFMedic1479's Avatar
FFMedic1479
All Star
Joined: Jan 2007
Posts: 982
Likes: 0
From: Connecticut
Default

I would be nervous with that. For the two obvious reasons that it would not work when you need it or it could go off at anytime. It may not be the module but one of the many sensors that detect the impact. If that is the case, it may only take a pot hole or nudge to set it off in your face. Or, again, not detect the crash if it occurs.
 
Reply
Old Aug 9, 2008 | 03:54 AM
  #3  
devildg84's Avatar
devildg84
Professional
Joined: Jul 2008
Posts: 118
Likes: 0
From: Greenwood IN
Default

or they may not have put the airbag back in that would keep the light on too
 
Reply
Old Aug 9, 2008 | 09:58 AM
  #4  
Parts/Service's Avatar
Parts/Service
Champion
Joined: Mar 2004
Posts: 2,703
Likes: 2
From: Bremen, GA.
Default

If the vehicle was wrecked, they would have needed to replace the clock spring as well as the air bags. Also the supplemental restraint system verification test procedure should be performed following service of any supplemental restraint system component. Have you had the vehicle scanned for codes to see why the light is actually on? The pre-tensioners in the seatbelts could also need replacing. Look and make sure the seatbelt electrical connectors are pluged in...
 
Reply
Old Aug 9, 2008 | 05:48 PM
  #5  
dwhaye's Avatar
dwhaye
Thread Starter
|
Junior Member
Joined: Aug 2008
Posts: 2
Likes: 0
Default Where is the clock spring located?

on a Dodge Ram 1500 2003?
 
Reply




All times are GMT -4. The time now is 12:30 PM.