This morning I had a vinyl graphics/detail shop install the emblems back on my truck, and when I got it back, it looked terrible; it looked like a child put them on. Not only do the placement of the emblems look bad, they aren't even at all. I could use your guys' opinion on where I should move the emblems to make them look right. I just finished spending $135 on these damn emblems and I need them to look right. Thanks!

 

yuck! the ram 1500 emblems are definately too low and the Hemi emblems are too high....
why not leave it debadged?
i would just put them back in the stock locations

Please tell me you didnt have the same shop that f****d up your detail awile back do this....

if you want it right you gotta do it yourself

 

move the hemi badge down a little bit and take off the ram 1500...

 

umm, stock locations? why the f did you just pay someone to put your emblems on?

 

you dont need any of them emblems leave people thinking you dont have a hemi....its more fun.

 

OMG that is terrible. I say just take them off. or put them in the stock location

 

bummer dude, i put mine back on after i painted them black, of course i had the shadows to kinda help me guide them back in place, but i used a straight edge level to make sure they were all on point. ill post pics if ya like

 

damn bro! You got screwed again! Are you starting to enjoy it? I wish I lived near you so I could make some of that money your paying other people to do stuff that you can do your self. At least you would be happy when I was through. Who ever did that is a f***ing moron!

 

like omg i know right, the ram 1500 part needs to be back to stock height and the hemi badge is too high and close to your antenna.

either that or redebadge the ram 1500 and then redebadge the hemi logo to move it lower then rebadge is there. unless if its the oem hemi badge then it would look better on the fender by the headlights

 

I'll wash your windows for $100.