3rd Gen Ram Tech 2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

New mods

Thread Tools
 
Search this Thread
 
Old Nov 9, 2009 | 08:54 PM
  #11  
PVHF_Richard's Avatar
PVHF_Richard
Thread Starter
|
Rookie
Joined: Dec 2008
Posts: 84
Likes: 0
From: Palm Harbor,Fl
Default

no it doesnt drone that bad, but i kinda like the drone
 
Reply
Old Nov 9, 2009 | 09:02 PM
  #12  
chambers's Avatar
chambers
Record Breaker
Joined: Dec 2008
Posts: 1,605
Likes: 1
From: VA
Default

Haha, well I didn't mind it at first but eventually I had to do something about it on mine. I ended up cutting the stock tailpipe so it dumped under the bed and it's a lot better.
 
Reply
Old Nov 9, 2009 | 09:11 PM
  #13  
PVHF_Richard's Avatar
PVHF_Richard
Thread Starter
|
Rookie
Joined: Dec 2008
Posts: 84
Likes: 0
From: Palm Harbor,Fl
Default

thats not a bad idea
 
Reply
Old Nov 9, 2009 | 09:32 PM
  #14  
chambers's Avatar
chambers
Record Breaker
Joined: Dec 2008
Posts: 1,605
Likes: 1
From: VA
Default

Yea I read about it on here and dodge talk and it worked, so if it starts to bother you then hack it off.
 
Reply
Old Nov 10, 2009 | 01:02 AM
  #15  
PVHF_Richard's Avatar
PVHF_Richard
Thread Starter
|
Rookie
Joined: Dec 2008
Posts: 84
Likes: 0
From: Palm Harbor,Fl
Default

do you got a pic of your setup
 
Reply
Old Nov 10, 2009 | 02:13 AM
  #16  
derricksmash's Avatar
derricksmash
V6 Ram Moderator
Joined: Jan 2008
Posts: 1,961
Likes: 0
From: Chicago
Default

sounds good. i don't think i'd wanna hear it rev though...
 
Reply
Old Nov 10, 2009 | 09:08 AM
  #17  
chambers's Avatar
chambers
Record Breaker
Joined: Dec 2008
Posts: 1,605
Likes: 1
From: VA
Default

There are a couple in my gallery of the muffler and where the y-pipe was cut out on mine. I pretty much just cut the stock tailpipe off where it turned down near the leaf springs behind the axle. Here is a pic
 

Last edited by chambers; Nov 10, 2009 at 04:48 PM.
Reply




All times are GMT -4. The time now is 12:35 AM.