When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
IDK. I think they might me slightly more narrow because I used a hammer to tap them all the way up on the axle and then used a C clamp to gently squeeze the threaded side in so I could get the top plates on. Once I did that i just tightened them down and that was it.
IDK what you want measured. I bought 1" blocks as thats all I needed to level mine out to the front. As for the axle tubes, IDK that either as I never measured. When I get out to the truck today I will try to remember and check. I keep a caliper in the truck