Anyone ever built a set of these?? Planning on building some this weekend for the truck, stop all the axle hop when i drop the clutch.

 

There's quite a few companies that make them. I plan on ordering cal-tracs eventually.

 

If you have the capability of doing metal fabrication, it isn't a problem. Just keep in mind that the geometry needs to be such that what you build doesn't bind with wheel travel. Cal-Tracs looks to be a simple parallel bar design, very efficient and nice looking.
Search for "heim joints" on eBay and you will find a lot of cool parts. You will also need left and righthand taps to thread the tubing to mount the heim joints. My last project was a custom control bar for my V10 Moto Guzzi when I extended the rear swing arm.
Good luck..

 

i plan on using just graphite bushings in some DOM, i can get them throuhg work for next to nothing, heim joints are so expensive.

 

IMHO, the heim joints look best. But nylon or graphite are also good. Maybe even better when compared to less than best heim joints.