When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
In the meantime JB weld the crack? At the very least you would not be bleeding gear oil all over. I would wait to install another housing until you know it will be ok.
Well the third housing will be going in soon. I am going to leave the pass. axle off of the truck though. I have an old axle that I can use the end of to bolt into the hub so my wheel bearing does not go bad.
You probably don't wanna hear this but you are putting way to much stress on your axle your best bet in the long run is to loose the leveling shocks and put the longer ones in from rough country
