I bought a Fortin Evo all and Thar 5 for my 06 ram 5.7 QC. It came flashed so I installed as per instructions. Final step was "programming". As soon s I turned key to on position, the programming light goes off, and does not program . Repeated steps numerous times. Finally called Fortin tech, they had me read voltage on the two gray wires coming from the ignition switch to the unit, 1 had about half a volt other had about 5 volts. As soon as I told the tech that he said there is the problem . That the can bus was unbalanced and I could not use this type remote start, unless the can bus problem was solved.

Anybody got any ideas???? really wanted a remote start .....

 

hello have you found a solution to your connection

 

Do you see the date of that post?