DodgeForum.com

3rd Gen Ram Tech 2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Clutch problems

   
Old Jun 11, 2015 | 05:48 PM
Share
  #1  
alston89's Avatar
alston89
Thread Starter
|
Registered User
Joined: May 2015
Posts: 3
Likes: 0
Default Clutch problems
2003 ram 1500 4.7....im having problems with the clutch, when i put it into 1st or reverse it grinds and needs to be forced..then when i accelerate it makes a squeaking noise....any ideas will be greatly appreciated
 
Reply
0
Old Jun 11, 2015 | 07:46 PM
Share
  #2  
chuck_hammer's Avatar
chuck_hammer
Veteran
Joined: Aug 2013
Posts: 365
Likes: 1
From: Ohio
Default
hydraulic clutch system may need to be bleed.... and the throw out bearing may be going bad.. and the clutch, pressure plate and flywheel inspected...
 
Reply
0
Old Jun 15, 2015 | 02:26 AM
Share
  #3  
beech2000's Avatar
beech2000
Rookie
Joined: Dec 2005
Posts: 60
Likes: 0
From: North Georgia
Default
Originally Posted by alston89
2003 ram 1500 4.7....im having problems with the clutch, when i put it into 1st or reverse it grinds and needs to be forced..then when i accelerate it makes a squeaking noise....any ideas will be greatly appreciated
I have the NV4500 5speed manual. On my third throw out bearing for same condition.
Make sure you stay with all Mopar parts.
 
Reply
0
Old Jun 15, 2015 | 10:39 AM
Share
  #4  
p38251's Avatar
p38251
Record Breaker
Joined: Feb 2011
Posts: 2,001
Likes: 0
From: Vanderpool Texas
Default
Throw out bearing squeak when the clutch is in. U joints will squeak under load.
 
Reply
0
Back to Subforum
3rd Gen Ram Tech
View Next Unread
Leveled 2500 Cummins offset question


Thread Tools
Search this Thread
Search this Thread:

Advanced Search

Advanced Search
Reply Closed Thread Share
Forum Jump

All times are GMT -4. The time now is 04:41 PM.