When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
does anyone know the size of that screw on filter. I like to try and "torque" it using a socket filter wrench. I appreciate your help.
Thanks
Any parts store will sell you the correct size filter given the correct information. Oil filters should be torqued hand till tight. Then half a revolution further with a wrench. Perhaps I'm reading your question wrong.
Any parts store will sell you the correct size filter given the correct information. Oil filters should be torqued hand till tight. Then half a revolution further with a wrench. Perhaps I'm reading your question wrong.
I was thinking that filter was a little smaller size. Also I was wanting to torque it but..maybe Im just over thinking it like I always do, maybe I will go with your suggestion about hand tightening I appreciate it..
Any parts store will sell you the correct size filter given the correct information. Oil filters should be torqued hand till tight. Then half a revolution further with a wrench. Perhaps I'm reading your question wrong.
Half a revolution more with a wrench? That's too tight. Hand tight and maybe snug it slightly with the wrench if needed.
