HPTuners and 3rd gens transmission options? 2005 2500?
#1
08-16-2020, 08:38 AM
HPTuners and 3rd gens transmission options? 2005 2500?
Nevermind, apparently it can't be tuned. with anything. according to HPTuners forums, and superchips.diablo.
Can anybody tell me, with 100% certainty, that HPTuners has transmission tuning options for a 2005 *2500* 5.7L ?
Their website only lists 1500's mainly, and the only other option I see is for 04-10 Ram 3.7, 4.7, 5.7, and there are no "additional supported controllers" for 2005.....
So is trans tuning actually available for my 2005 2500 5.7L?
Can anybody tell me, with 100% certainty, that HPTuners has transmission tuning options for a 2005 *2500* 5.7L ?
Their website only lists 1500's mainly, and the only other option I see is for 04-10 Ram 3.7, 4.7, 5.7, and there are no "additional supported controllers" for 2005.....
So is trans tuning actually available for my 2005 2500 5.7L?
Last edited by GRNDPNDR; 08-16-2020 at 10:32 AM.
#2
08-17-2020, 10:29 AM
It looks like there MIGHT be an option to swap out the PCM.
HemiX2 over at HPTuners forums has managed to swap out a NGC3 PCM in his 06 Jeep with an 08 NGC4 IIRC.
The problems so far is he hasn't sorted out the MIL code issue with all the stuff on CAN C bus.
This leaves me wondering if I could swap an 07 PCM into my 05 and what pins might be different.
looking like it could be very costly though, but mainly because I don't have a scanner that can change the VIN in anything like an Autel, and they're like $1500+ So there's that.
But I also need to figure out how to find out what PCM I have on my truck currently, whether it's a NGC3 or NGC3 CAN .... I'm assuming it's the former because CANBUS didn't start until 2006 if I'm not mistaken, and when I connect my Innova it's connects to JPW instead of CAN.
HemiX2 over at HPTuners forums has managed to swap out a NGC3 PCM in his 06 Jeep with an 08 NGC4 IIRC.
The problems so far is he hasn't sorted out the MIL code issue with all the stuff on CAN C bus.
This leaves me wondering if I could swap an 07 PCM into my 05 and what pins might be different.
looking like it could be very costly though, but mainly because I don't have a scanner that can change the VIN in anything like an Autel, and they're like $1500+ So there's that.
But I also need to figure out how to find out what PCM I have on my truck currently, whether it's a NGC3 or NGC3 CAN .... I'm assuming it's the former because CANBUS didn't start until 2006 if I'm not mistaken, and when I connect my Innova it's connects to JPW instead of CAN.
