And let the modding begin...
Thread Starter
|
Administrator
Joined: Jul 2007
Posts: 24,686
Likes: 21
From: South Georgia/East Florida
And let the modding begin...
OK, it ain't much. Just the toolbox I took off of Big Red. But I did spend the better part of two hours scrubbing it and applying aluminum polish on it before installing it...
Last edited by HammerZ71; Aug 31, 2014 at 12:11 PM.
Thread Starter
|
Administrator
Joined: Jul 2007
Posts: 24,686
Likes: 21
From: South Georgia/East Florida
It'll be a little while on that. Tires in the size I have planned will require wider wheel and I need to save some coin after purchasing the truck. Not planning anything drastic height-wise, just a level and some 35s. But I want the wide stance I had on the Hemi...
Ain't pulled nuthin' but my fat a$$ yet. Probably won't too much more than the ATV until November, when I take some time off to head hunting in Ga. Then I'm sure I'll have a 7700# tractor to tote...
Ain't pulled nuthin' but my fat a$$ yet. Probably won't too much more than the ATV until November, when I take some time off to head hunting in Ga. Then I'm sure I'll have a 7700# tractor to tote...
Thread Starter
|
Administrator
Joined: Jul 2007
Posts: 24,686
Likes: 21
From: South Georgia/East Florida
Happy with the way the tool box came out. Not bad looking for a box been in the deep southern sun for 10 years.
Nerf bars on order, went with the Dominator IIs. Level probably a month or two away.
Nerf bars on order, went with the Dominator IIs. Level probably a month or two away.