Ive purchased a cut out bumper for dual exhaust.

Im trying to figure out which of the 2 kits i should be buying for my truck.

http://www.magnaflow.com/07techtips/pdfs/16869.pdf

http://www.magnaflow.com/07techtips/pdfs/16870.pdf


I see there is a 3.5" tip on the 16870 and its attached by clamps.

The 16869 is welded tips and its 5.0".

Ive checked the bottom of my truck and it already has the hanger for the muffler that the 16870 kit provides.


Any input would be awesome, i'm kind of confused after seeing these 2 options.

 

Just received the dual cutouts bumper today! Had it installed in about 30-45 minutes. Easy conversion!

Only PIA was taking needle nose pliers and squeezing the plastic tabs inwards to pull the plastic step cover over the top of the bumper. Once that was off it was cake!

Putting the bumper back on after it was assembled took about 3-5 mins.

Now...the exhaust kit should be in tomorrow. I cant wait!

 

Conversion complete! Magnaflow system looks great. Not sure if I am a fan of the clamped tips. Defiantly 100% better looking than it was before!