Bed rail caps buckling again.
#12
The Dee Zee black diamond plate ones i ordered directly from Dee Zee attached over the oem crappers with much 3m double sided tape.And the tailgate piece only covers about half the gate.Im very satisfied.I have always had good luck with dee zee products.If you go directly to dee zees website, before you order them , they make you read and check a disclaimer stating that they dont work without the factory plastic still intact.
Last edited by SMGFATMAN71; 09-03-2013 at 02:46 PM.
#14
#15
The Dee Zee black diamond plate ones i ordered directly from Dee Zee attached over the oem crappers with much 3m double sided tape.And the tailgate piece only covers about half the gate.Im very satisfied.I have always had good luck with dee zee products.If you go directly to dee zees website, before you order them , they make you read and check a disclaimer stating that they dont work without the factory plastic still intact.
Rob
#16
Yes, thats what they said, and thats how i did it, upon thinking about what you guys did , i like the idea of ripping off the oem warppers , and just sticking them right to the bed.This set looks fine, but my oem crappers werent in warp drive yet,[third set in 4 years].Next time, if needed , im going with no limits idea.
#17
#18
Hi All:
My 2013 SLT Big Horn is only 6 weeks old and after reading this thread I went to check on mine. I found they are attached with plastic spring clips that are inserted thru holes in the bed at least 4-5 per side. As this is a very late 2013, June 4, 2013, maybe a change was made to rectify the problem?
jimf5
My 2013 SLT Big Horn is only 6 weeks old and after reading this thread I went to check on mine. I found they are attached with plastic spring clips that are inserted thru holes in the bed at least 4-5 per side. As this is a very late 2013, June 4, 2013, maybe a change was made to rectify the problem?
jimf5
#19
Hi All:
My 2013 SLT Big Horn is only 6 weeks old and after reading this thread I went to check on mine. I found they are attached with plastic spring clips that are inserted thru holes in the bed at least 4-5 per side. As this is a very late 2013, June 4, 2013, maybe a change was made to rectify the problem?
jimf5
My 2013 SLT Big Horn is only 6 weeks old and after reading this thread I went to check on mine. I found they are attached with plastic spring clips that are inserted thru holes in the bed at least 4-5 per side. As this is a very late 2013, June 4, 2013, maybe a change was made to rectify the problem?
jimf5
Rob