sent you a pm with that info

 

Have a kegger from a 95 Ram that has the runners cut all the way down and the EGR plate cut out from the center. Has been matched to a 50mm at the opening and I sanded the runners and the ports till baby smooth. Here is a few pics when painted and before baked. I am currently clear coating over the silver. Asking $100 + shipping or $135 shipped. Last picture is before is was shined up and is now smooth and shiny all around

 

bump

 

gasket surfaces will be all clean and will clean as much of runners as i can reach

 

all done and cleaned up want this gone today so $105 shipped to your door. Has an EGR block off plate so will fit EGR or those with no EGR. Again $105 shipped to your door

 

any takers?

 

I noticed that the intake ports in the 2nd post was ported. Did you gasket match them? Free bump.

 

didnt gasket match as i dont have any gaskets to match

 

Have a 96 5.2/5.9 intake manifold that i cut the runners down and took out all of the middle plate. Then sanded and polished inside and did the same with the runners. Painted it aluminum color. Asking $70 shipped. Need this gone just pm with any questions. Pics will come later tonight

 

pics!