I have a 98 Jeep Grand Cheokee 5.9 that I HAVE to part out. (I got laid off several mos ago and am a single dad of 4 kids)

I am selling:

Complete Motor! PCM, Harness, Accessories, Throttle body, etc.
This is a 360 Stroker Motor with about 1,200 mis. on it! I spent over $6k on this motor and drove it for a few months until it shattered the stock tranny. Unfortunately, I haven't been able to fix the tranny and since it wasn't my daily driver, it has just sat in the garage; now I have to sell it. The motor was built for power, bored .30 over, blueprinted & balanced, custom cam & bench-dyno'd at 417HP! As if that wasn't enough, I also added a Tuned PCM*, Ported Throttle Body (53mm)* & Ported/Polished MOPAR 2BL M1 Intake*. (from Dan at fastman.com) I took very good care in breaking it in as I never planned on parting with my beloved Jeep, but life happens. $3,500-OBO

Other items under the hood
New 3-core Aluminum Radiator-$150
New A/C Condenser, rails, heater box, etc.-$150
K&N FIPK Cold-Air kit-$100
O.E. Master cylinder-$75

AXLES
Front- Dana 44-"Rubicon" Axle w/ Stock air locker, 4.10's, Custom High-Steer conversion, Slotted & drilled Rotors w/ 2 piston calipers- $1500-OBO

Rear- Dana 44 Stock - 4.10's, stock soft-locker, Disc brakes-$1,000-OBO

Thanks for looking, LMK if you have any questions.