01 ram radio install/ no sound
#1
#3
#6
#7
Trending Topics
#10
RE: 01 ram radio install/ no sound
— 29 — There are 3 sets of av jacks on the back of the Kenwood. a rear a front and a non fading. If these are not hooked up willI have no sound? Dont know where they go?
ANT.
CONT
ILLUMI
P.CONT
FRONT • L
FRONT • R
REAR • L
REAR • R
– +
NON FRONT
REAR FADING
Connecting Wires to Terminals
FM/AM antenna input
15
10
Rear left output (White)
11
Rear right output (Red)
Fuse (10A)
27 Wiring harness
(Accessory
28[size=6]29)22
28
White/Black
31
Gray/Black
34
Green/Black
37
Purple/Black
White
30
Gray
33
Green
36
Purple
39
To front left
speaker
29
To front right
speaker
32
To rear right
speaker
38
To rear left
Ignition wire (Red)
46 speaker 35
Battery wire (Yellow)
47
Ground wire (Black)
- (To car chassis) 48
Ignition key
switch
41
Car fuse box
(Main fuse)
42
ACC
44
Car fuse box
45
Battery
43
If no connections are made, do not let the wire come out from the tab.
3
14
Front left output (White)
13
Front right output (Red)
12
Non-fading right output (Red) (KDC-MPV7019/X459/4019 only)
Power control wire (Blue/White)
16
Motor antenna control wire (Blue)
17
Dimmer control wire (Orange / White)
(KDC-MPV7019/MPV619/X459/419 only)
19
4
When using the optional power amplifier,
connect to its power control terminal.
7
To car light control switch
5
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna, or
to the power terminal for the booster amplifier of the
film-type antenna.
49
Non-fading left output (White) (KDC-MPV7019/X459/4019 only)
To KENWOOD disc changer/
DAB control input/KPA-SD100/
KPA-HD100/KPA-SS100
25
To connect these leads,
refer to the relevant
instruction manuals.
26 thTTt