Hey guys looking into getting a back up camera installed into my indash monitor... i was wondering which one u guys recomend and also if any one has installed this, how did u run the cables from the back to the front into the dash? any help or opinions are well appriciated.

 

What year ram. When I do the newer style, I run the cable from the rear, to just under the cab corner, in the cross member of the frame, there is a small hole, fish the wire through that hole and make it do a 90* turn towards the outside of the truck. When it gets to the end of the crossmember it will poke out inside the cab at the bottom of the cab corner. Inside the truck you can get to that spot by taking out the panel over the cab corner, then removing the seatbelt mechanism, reach down into the cab corner and you'll feel a foam covered piece of plastic. Pry that out and the hole the wire will poke through will be at the very bottom. It's kind of a pain, but it's nice and clean and no drilling involved.

Fishing it through the frame is the hardest part, but between both sidesI managed to fish a total of about 8 sets of 12Gspeaker wire, 3 sets of tripple shielded rcas, remote wire, and the back-up cam cord. It definatly wasn't fun and it was a tight fit, but I managed, so that single cable shouldn't be too bad.

 

hahahaha....sounds like a real blast!