4th Gen Ram Tech 2009 - 2018 Rams and the 2019 Ram Classic: This section is for TECHNICAL discussions only, that involve the 2009 - 2018 Rams and the 2019 Ram Classic. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

mopar brake controller installation

Thread Tools
 
Search this Thread
 
Old Jul 27, 2011 | 04:02 PM
  #1  
mdram43's Avatar
mdram43
Thread Starter
|
Record Breaker
Joined: Feb 2007
Posts: 1,552
Likes: 0
From: Rockville, MD (right outside DC)
Default mopar brake controller installation

so i called my local dealer to buy the brake controller and they said they couldnt get it. after I just found it on multiple sites. So i went ahead and ordered it from http://www.dodgechryslerparts.com/pr...oducts_id=2190

and it arrived today. upon reading the instructions it says I need a sales code and then another code from the dealerships service dept. upon further reading i see you need to hook a computer up to it and so on. So I'm taking it, I cannot install this to save some money? Anyone have any experience?
 
Reply
Old Jul 27, 2011 | 04:55 PM
  #2  
jayman84's Avatar
jayman84
Captain
Joined: Aug 2009
Posts: 570
Likes: 2
From: middle of the state, IA
Default

From what I have seen it should be plug and play but you need to have your dealer hook your truck to their computer so that you can read the brake controller through your evic screen. If you don't care about it showing up on your evic then just plug it in and forget about the trip to the dealer.
 
Reply
Old Jul 27, 2011 | 09:22 PM
  #3  
frogslinger's Avatar
frogslinger
Captain
Joined: Mar 2005
Posts: 639
Likes: 0
From: Dyess, TX
Default

From what I have heard you can install it yourself and it will work but will not integrate with your DIC so you will not know what setting it is on etc... it will also set a soft code in your ECM for an extra canbus device (which is invisible to the end user).

So yes and no...
 
Reply
Old Jul 29, 2011 | 08:20 AM
  #4  
oyen24's Avatar
oyen24
Professional
Joined: Jun 2009
Posts: 179
Likes: 0
From: Richland Center WI
Default

I just took the one out of my 03 silverado when I bought my new 09 ram and just got the wiring harness from my local napa auto parts, plugged it in, and wired it up and that was it. Didn't go to the dealer for anything. Mine is an aftermarket one, so it may be a little different from the mopar one.
 
Reply
Old Jul 29, 2011 | 11:03 AM
  #5  
newmexicoram's Avatar
newmexicoram
Veteran
Joined: Sep 2008
Posts: 313
Likes: 0
From: Rio Rancho, NM
Default

I had mine installed by the dealer. The bottom line was $76.03. That way if it doesn't work properly...They installed it!
 
Reply
Old Jul 29, 2011 | 05:25 PM
  #6  
The Craig Machine's Avatar
The Craig Machine
Rookie
Joined: Aug 2010
Posts: 58
Likes: 0
From: Ontario
Default

Sounds like a pretty stupid setup. I have an aftermarket one that the rv dealership installed when I bought my camper. Works great. And I bet it was a fraction of the cost of the mopar part.
 
Reply
Old Jul 29, 2011 | 09:57 PM
  #7  
frogslinger's Avatar
frogslinger
Captain
Joined: Mar 2005
Posts: 639
Likes: 0
From: Dyess, TX
Default

It is actually an awesome setup. The reality of modern day vehicles is that they have an integrated system. It is the same as plugging a new device into a computer... sometimes everything works just fine, sometimes only certain features work until you download the latest drivers...
 
Reply
Old Jul 29, 2011 | 11:33 PM
  #8  
mdram43's Avatar
mdram43
Thread Starter
|
Record Breaker
Joined: Feb 2007
Posts: 1,552
Likes: 0
From: Rockville, MD (right outside DC)
Default

stealership charged me $300 plus tax. ridiculous
 
Reply
Old Jul 30, 2011 | 12:41 AM
  #9  
dpartsguy's Avatar
dpartsguy
Registered User
Joined: Jul 2011
Posts: 2
Likes: 0
Default

Dealerships dig their own grave. There are a few that will give you a good deal. I know that these sites are ran by a dealer and have ok prices. www.dodgetruckparts.net www.dodgeparts.co www.dodgedieselparts.net
 
Reply
Old Aug 1, 2011 | 11:26 PM
  #10  
mdram43's Avatar
mdram43
Thread Starter
|
Record Breaker
Joined: Feb 2007
Posts: 1,552
Likes: 0
From: Rockville, MD (right outside DC)
Default

that was just on install, the dealership tried telling me they couldnt even get it, so I got it off the site I listed before
 
Reply



All times are GMT -4. The time now is 04:14 AM.