My wheels were a bit plain to me. I used one inch vinyl striping to enhance em. I put in in the little wdges on each spoke. Turned out cool. Took a while but cost very little.

 

Grinner,
Are those the Stock Wheels? If so, where did you apply the Vinyl Stripping? On the inside of the spokes? They look black inside. Also, looks like a trim around the outside of the rim, between the spokes and the outer wheel. Whatever the case, looks good...

[8D]

 

I can't tell where you put them with just that pic, but either way, your Magnum looks hot [sm=smiley20.gif][sm=smiley20.gif]




-Matt-

 

You keep moving that bar...UP!

Very Nice!

 

these are the the wheels before the black tape:
http://www.mc2ning.com/dodge/fz7.html
It's great striping so it otta hold up fine. It's metallic black so it matches the paint perfectly.
I can get some closer pics if ya like.

 

Very nice...

Did you notice a differance in the ride when you went to the bigger wheels?

Rex

 

never drove it on stock wheels.
The dealership put these on and I was able to finance em with the payments of the car.
This is the smoothest ride I've ever had though.

 

Very impressive. You have done a great job!

Rex

 

thanks man.
went ahead and tore into the foglights and brakelight as well...



the pic of the brakelight doesnt do it justice cuz of the flash. It looks really clean. Like a quarter inch bar or LEDs.
not bad for 25 bucks and 140 feet left of metallic black striping.

 

and here I was thinking that you were using up that extra roll of black electrical tape...

Must be nice having patience...

Mike