It's going down tonight
 

Me and a buddy are headed to the track to end 4 months of S$*talking about his ford falcon. I am going to race him stock with my topper on against his 1964 falcon with a built 289. I think he will run out of gearing about the 1/8 mark. Anyhow I was looking for a few pointers on the best way to shut him down. I figured I will have to run in 4x4 to keep tire spin under control, but should I run in tow/haul? How about spool up at the line? Kinda nervous about this one.

RE: It's going down tonight
 

I would test the hook up in 2 wheel drive. If it is good then I would keep it in 2 wheel drive. 4 wheel drive will bog you down.
also make sure you sppool the turbo before you launch otherwise he will smoke you off the line.

RE: It's going down tonight
 

4wd hi, plant the break pedal to the floor, rev to around 1600rpm and build some boost. once the green light hits you should know what to do. around half track you can switch back to 2wd, by then wheel spin should not be an issue.

theres no real need to do a huge brake stand burn out, butI wouldspin the tires a little to remove any FOD from the rubber.;)

RE: It's going down tonight
 

Any opinions on tow/haul? Also is it safe to shift to 2wd while the engine is at full power?

RE: It's going down tonight
 

I would do tow haul simply due to the TC locking earlier and holding the gears a bit longer. however what you can do is make a run both ways if possable, one without tow haul and the other with to see what, if any difference.

Ive shifted into 4wd under full power before;)had a ricer I needed to get around and was getting a bit too much wheel spin.

RE: It's going down tonight
 

Thanks for the input, I will let you all know the results later tonight!

RE: It's going down tonight
 

If it is a 289hypo with a 4sp and 4.10 gears your going to have your hands full they were quick.
Ford made a limited number of them for the strip (just enought to be classed as stock)

RE: It's going down tonight
 

All of the above witha C-4 auto, roush heads etc... I just think the tires are too small/narrow, this is what I am hoping to gain an edge with. 2 hours and ticking

RE: It's going down tonight
 

remove a valve stem core when he's not lookin! :D

RE: It's going down tonight
 

Shove a bananna up his tail pipe.

http://www.screenhead.com/wp-content.../03/eddie1.jpg