Take Pics..

 

Give it about a mounth and u will be cussing recon trust me. I had 3 sets of them and nothing but problems. Something to do with the LEDs you'll have one dim and the others will work right. I got tired of sending them back and just put the stock ones back on. Hope you have good luck.

 

I Hope Not.

But Now That You Said That, Heath at Recon Said ANYONE Who Has An Issue With Their Product Just Call Them. They Will Take Care of You, If They Don't. Tell Me, After All The Suport I Have Given Them, I Will Give Them My .02*

 

I entered the promo code which gave the discount, but they charge $14.99 for shipping. No savings there, think I can still get free shipping somehow?

 

I haven't had any problems with mine. I didn't have lights before so I cut the plugs off of the recon lights and hard wired them myself. Myabe the recon plugs are causing the dimming you are talking about?

 

is this discount just for cab lights or is it for other lights too?

 

negatives on Recon cab lites.
Factory lights are slightly curved on the bottom to match the roofline. Recon aren't, and when you put them on and tighten the screws the roof deforms slightly and is noticeable.The gasket system on the factory is excellent. I tried using the gasket on the recons , but because they are flat it wouldn't seal properly.Recon should redesign with a better fit.

 

mine fit just fine with the stock gaskets. The supplied screws with the recon lights suck. I used the stock screws. Bigger heads, so I could tighten them down more without the rubber washers tearing.

 

I pretty much just did the same on my install. Without the stock gasket there is about 1/8" gap, so i used the supplied screws because they were longer and reinstalled the stock gasket along with the stock plastic washer on top of the recon rubber washer, so it didnt pop out. Kinda a pita but turned out pretty good, now I just hope it doesnt leak.