Dodge/Ram Diesel Tech Discussions on all generations of Cummins Diesel powered Rams plus the new Eco Diesel

2 more questions?

Thread Tools
 
Search this Thread
 
  #11  
Old 02-01-2007, 09:53 PM
htgriffith's Avatar
htgriffith
htgriffith is offline
Veteran
Join Date: Aug 2006
Location:
Posts: 398
Likes: 0
Received 1 Like on 1 Post
Default RE: 2 more questions?

Will a K&N filter cause my vehicle’s mass air sensor to fail?

No, it is both impossible and ridiculous.
It is impossible because we know that the oil treatment on our cotton is very small (usually less than 2 ounces). Once the oil is properly and evenly absorbed through the cotton, no oil will come off, even under extreme engine conditions. It is ridiculous, because no dealership or service provider has ever been able to provide us with evidence to support this “myth,” and in fact, our investigations have revealed that even authorized dealerships are simply speculating and do not have the test equipment necessary to know whether the sensor has failed or why. It is even more ridiculous because some car manufacturers use and sell air filters treated with oil on a regular basis. There are also major brands of disposable air filters that are treated with oil. We all use oil for the same reason, it helps in the filtration efficiency of an air filter.
Out of the millions of air filters we sell, we only receive a handful of consumer complaints each month that a dealership or service provider has blamed a vehicle sensor repair on our product. We take each complaint very seriously and see it as an opportunity to stop a consumer from being taken advantage of. We investigate the situation thoroughly and take full responsibility for resolving the issue. For more information on how we educate and persuade the service provider to reconsider their position, see Mass Air Flow Sensor Information & Testing. We are so confident in our ability to resolve these situations and help a consumer fight back that we offer our Consumer Protection Pledge.

As a result of our standing up for consumer rights and providing assistance to resolve a disagreement, we have had 77 actual sensors sent to us by dealerships who claimed our product had caused them to fail. Microscopic, electronic and chemical testing revealed that none of the 77 sensors were contaminated by K&N oil (K&N Detailed MAF Sensor Test Results). What is perhaps the single biggest clue to what is going on is that over 50% of these sensors were not broken in the first place for any reason. Click here for more information on how this may happen. For more information on this topic, see our Mass Air Flow Sensor Statement page.
 
  #12  
Old 02-02-2007, 03:53 PM
MrSlug's Avatar
MrSlug
MrSlug is offline
Veteran
Join Date: Nov 2006
Location: BayArea,CA
Posts: 481
Likes: 0
Received 0 Likes on 0 Posts
Default RE: 2 more questions?

ORIGINAL: htgriffith

Will a K&N filter cause my vehicle’s mass air sensor to fail?

No, it is both impossible and ridiculous.

It is possible to oil your KN soo much that it will bleed oil when under full boost. Wether or not that oil gets pulled all the way through the turbo, passed the intercooler to clog up the MAF/MAP sensor is probably debateable.

Search on DTR or TDR on this problem.There was supposedly a case where over oiling the filter caused a sensor to fail and engine damage was a result. I would have to imagine in that case, the person must have used the whole freeking bottle of oil and the filter was dripping like a ****.

Again, I don't believe a KN filter, used properly, will ever hurt your motor.
 
  #13  
Old 08-18-2007, 01:51 AM
chelle26's Avatar
chelle26
chelle26 is offline
Join Date: Aug 2007
Posts: 3
Likes: 0
Received 0 Likes on 0 Posts
Default RE: 2 more questions?

for your question #1: i never used to install k&n but i've heard it was a great type air filter..have you tried dodge neon air filter ? i had installed it once and it was great for me..but i wasn't sure with the cost distinction between the two..


 



Quick Reply: 2 more questions?



All times are GMT -4. The time now is 11:22 AM.