Lower class club...
Champion
Joined: Jun 2009
Posts: 3,210
Likes: 0
From: Collinsville, Oklahoma
what bar tom? are you talking about where the hellas are? i just mounted them to the frame crossover. if you want i will get pics. shoot me your email and i will post how to link as it is not DF friendly
Champion
Joined: Jun 2009
Posts: 3,210
Likes: 0
From: Collinsville, Oklahoma
yeah i have seen those but i went the cheap route and drilled the frame. i can take pics in a bit,my camera battery is dead. as far as the wiring i just followed the instructions that came with the lights. red to battery, blue is ground , black is power to lights, yellow is to the switch if i remember right. it was really easy. i mounted my switch in the little cubby below the ac controls so it is hidden but that is how i like my stuff. i tied both the grounds, from the relay and from the lights, to the same place the battery ground. it was a lot of wire fishing but it is really clean and worth it
Champion
Joined: Jun 2009
Posts: 3,210
Likes: 0
From: Collinsville, Oklahoma
here are some pics of how i did mine
switch location
mounted on the frame
where i grounded the relay and lights
where i mounted the relay. it was where my amp fuse hlder is but i moved it down a little bit.
and where i ran the wire for the switch through
tom i hope these help. i can answer ? if you have any. -mike
switch location
mounted on the frame
where i grounded the relay and lights
where i mounted the relay. it was where my amp fuse hlder is but i moved it down a little bit.
and where i ran the wire for the switch through
tom i hope these help. i can answer ? if you have any. -mike
Last edited by OklaHemi; Jan 21, 2010 at 06:34 PM.
Thread Starter
|
Grand Champion
Joined: Apr 2007
Posts: 5,930
Likes: 1
From: TAMPA BAY
mike thats where i run my wires thru too but everytime i goop a lil rtv on there so bugs and shiz dont get in....where you get those strip leds they just stick on right? post up some pics of your interior i have never seen it...do you have a silver coverlay kit in your truck ? i was thinking about buying a brushed aluminum one to enhance my interior but i want a quality kit not just vinyl.....
Last edited by BadHab1t; Jan 21, 2010 at 06:02 PM.
Champion
Joined: Jun 2009
Posts: 3,210
Likes: 0
From: Collinsville, Oklahoma
my bezel is stock that way, laramie sport. im going to seal up the grommet the weather has just been ****ty and is hopefully finally starting to clear up because i know once i get the hood on the roll pan will follow and then the front bumper. i got the led's at advance auto, they are optix 3" neo blue. i have some 16 or 18" stripes on either side of the center console i will get you pics when i get it cleaned up. it is pitiful right now
Champion
Joined: Jun 2009
Posts: 3,210
Likes: 0
From: Collinsville, Oklahoma