I think any 02-08 should work, but start with 06 obviously! Mine is a thick abs plastic, but held up great! The main thing is it lets it slide over rather than the frame rails digging in! Or your transfer case catching on something!! And on Falls Dam there were several times I had to keep enough momentum going to keep from getting high centered. the engine would rev a little when all four tires were about off the ground then catch as I slid over! Without the skid plate I could have broke something for sure!!

 

i'll look but not sure if i'll find one at a decent price...

 

I will keep my eyes open also in my junk yard diggin!

 

thinks, around here they charge a crap ton

 

Yeah they do. Especially Odums and any of the J-ville ones.

 

ya you know what i'm talking about...

 

wow there is a place in Marion called JT's and all they have is truck parts! some new some used, but prices all seam good I will check with them and a couple otheres

 

The only junkyard I ever go to anymore near me is LQK. They barely charge anything. I bought an nv3500 5 speed for $115 after tax and their lot fees.

But sadly, ever since they moved all the C4C cars and trucks through there, they haven't had much of anything recently for gen 1 dakotas.

 

thanks SMKNRAM, i fixed my rear seal and next comes replacing the struts and tirods

 

yea, odums was the only place that had my yoke i needed. i need another one too.. but im down for the next one. by then ill be locked.

but if anyone can look around for a yoke for me, it would be great. Dana 60 ( 29 spline) from a dodge (2nd gen) 2500 or 3500