Need help with starting my 1988 dodge w250
Thread Starter
|
Registered User
Joined: Jul 2023
Posts: 12
Likes: 0
Need help with starting my 1988 dodge w250
My truck will start but most of the time will not fire off until I roll of of the ignition switch to the run position. If I keep turning the key trying to turn the engine over, it will flood. What could be my problem? I have to roll off of my ignition switch to the run position before my engine fires off
Grand Champion
Joined: May 2019
Posts: 5,134
Likes: 718
From: S.W. Indiana
My truck will start but most of the time will not fire off until I roll of of the ignition switch to the run position. If I keep turning the key trying to turn the engine over, it will flood. What could be my problem? I have to roll off of my ignition switch to the run position before my engine fires off
There is an engine run position and an engine start position. It sounds like your switch might be bad. Keep in mind the switch is on the steering column, not the key cylinder.
Thread Starter
|
Registered User
Joined: Jul 2023
Posts: 12
Likes: 0
Switch
I have replaced the ignition switch in the last two weeks. Before it had a button to push ran up to the dash that engages the starter. Since I replaced ignition switch, I no longer need to use the button to engage the starter. But either way it will not fire off until I roll it back. Before the new ignition switch I put in. I had to turn the key off and on to get it to fire off.
