My Post Pictures

May 6, 2022

8

0

This 12k pound Badland winch will fit just fine, I can either space the front bumper out 3/4" or I can Notch the lower radiator support on one side or the other to clear the motor (See second pic for detail)

This 12k pound Badland winch will fit just fine, I can either space the front bumper out 3/4" or I can Notch the lower radiator support on one side or the other to clear the motor (See second pic for detail)

0 2022/05/06 07:01:15 cheeseburg

I had to clock the gearbox on this winch to allow the free spool lever to be accessible, I am going to try it like this, but if it's too difficult to get to, I will re-clock the gearbox to have it accessible from underneath the front bumper

I had to clock the gearbox on this winch to allow the free spool lever to be accessible, I am going to try it like this, but if it's too difficult to get to, I will re-clock the gearbox to have it accessible from underneath the front bumper

0 2022/05/06 07:01:18 cheeseburg

This is the Lower Radiator support bar that i'm going to notch and bolt a piece of steel to the back of to restore it's strength

This is the Lower Radiator support bar that i'm going to notch and bolt a piece of steel to the back of to restore it's strength

0 2022/05/06 07:01:28 cheeseburg

This is the Base of the frame I made, I still need to add a LOT of re-enforcement and add some sort of bracing from the winch plate to the fairlead mounted on the front bumper.

Or I may decide to add the fairlead behind the front bumper and hide it with a license plate. I haven't decided yet.

This is the Base of the frame I made, I still need to add a LOT of re-enforcement and add some sort of bracing from the winch plate to the fairlead mounted on the front bumper. Or I may decide to add the fairlead behind the front bumper and hide it with a license plate. I haven't decided yet.

0 2022/05/06 07:01:31 cheeseburg

My plan is to replace the factory bumper studs with 5/16 Grade 8 Hardware and some Very thick washers.

I still need to make the bars that will tie back to the factory tow hook bolts top and bottom.

My plan is to replace the factory bumper studs with 5/16 Grade 8 Hardware and some Very thick washers. I still need to make the bars that will tie back to the factory tow hook bolts top and bottom.

0 2022/05/06 07:01:51 cheeseburg

0 2022/05/24 07:15:50 cheeseburg

0 2022/05/24 07:16:17 cheeseburg

Pic for Attention.

Pic for Attention.

0 2026/02/09 19:58:49 cheeseburg