DodgeForum.com
Still need to install the new foglights and grill but it's finally on the truck!!
Still need to install the new foglights and grill but it's finally on the truck!!
0 2012/08/20 17:05:46
all the mounting hardware for the bumper was replaced also,gave me an opportunity to touch up some minor surface rust spots on the frame and radiator support
all the mounting hardware for the bumper was replaced also,gave me an opportunity to touch up some minor surface rust spots on the frame and radiator support
0 2012/08/19 11:12:15
old parts removed and ready to go back together...
old parts removed and ready to go back together...
0 2012/08/19 11:12:15
mod6-step6, I carefully pryed the pc up,it's glued under the actuators so I was careful releasing it.set a spacer inCAREFULLY and desoldered the mini relay.Cleaned it up and installed the new relay.Couple dots of silicone to reglue the p\c down and reassemble...Done
mod6-step6, I carefully pryed the pc up,it's glued under the actuators so I was careful releasing it.set a spacer inCAREFULLY and desoldered the mini relay.Cleaned it up and installed the new relay.Couple dots of silicone to reglue the p\c down and reassemble...Done
0 2011/10/12 19:08:30
mod5-step5, Power connection and main harness connection straight across.You should desolder these and remove the p\c from the upper case.I just resoldered them and touched any solder points I could reach without burning anything.
mod5-step5, Power connection and main harness connection straight across.You should desolder these and remove the p\c from the upper case.I just resoldered them and touched any solder points I could reach without burning anything.
0 2011/10/12 19:08:30
mod4-step4,This is the culprit.Seimans T72M mini PCB.They fail and keep the pump running.Found on internet for $1.68.I got mine at RadioShack..The SPDT relays they stock are lighter volt/amp but they can order it.When I looked there was one in the drawer,just lucky.
mod4-step4,This is the culprit.Seimans T72M mini PCB.They fail and keep the pump running.Found on internet for $1.68.I got mine at RadioShack..The SPDT relays they stock are lighter volt/amp but they can order it.When I looked there was one in the drawer,just lucky.
0 2011/10/12 19:08:30
mod3-step 3,Notice screw drivers as spacers to help with cutting.Keep your thumb on the connector,push down on it.TheP\C board is glued in the case,if you don't push down on the conn,you'll be pulling on the board and it may break
mod3-step 3,Notice screw drivers as spacers to help with cutting.Keep your thumb on the connector,push down on it.TheP\C board is glued in the case,if you don't push down on the conn,you'll be pulling on the board and it may break
0 2011/10/12 19:07:02
mod2-step 2, cut along outer edge between halves,using small spacers as you cut around makes it easier,There's a lot of sealant.
mod2-step 2, cut along outer edge between halves,using small spacers as you cut around makes it easier,There's a lot of sealant.
0 2011/10/12 19:07:02
mod1-step1, cutting sealant around power conection.Need to cut deep,there's a lot of sealant
mod1-step1, cutting sealant around power conection.Need to cut deep,there's a lot of sealant
0 2011/10/12 19:07:02