Steering Knuckle Install???
#1
Steering Knuckle Install???
I'm trying to install the steering knuckle after replacing the ball joints on my 1996 Dodge 2500 (2WD). I can get the lower ball joint nut started but the upper ball joint stud won't reach far enough thru the steering knuckle hole to get a nut started. I have the lower control arm jacked up also. I double checked and my replacement ball joints have the same length studs. And it's not that the upper ball joint stud is too big in diameter.
Is there a trick to this?
Is there a trick to this?
#2
#3
#4