When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
20 to 25 ( inch pounds will be good) they also make a spacer with a shim kit to replace the crush sleeve on the 9.25, its very nice because if you ever have to take it back apart, you wont need to buy another crush sleeve, basically just torque the nut back down and you'll have the same preload on the bearing...
20 to 25 ( inch pounds will be good) they also make a spacer with a shim kit to replace the crush sleeve on the 9.25, its very nice because if you ever have to take it back apart, you wont need to buy another crush sleeve, basically just torque the nut back down and you'll have the same preload on the bearing...