ok was hoping some of the vets around here may know whats happening here(BV..Silver)
my brake warning light/e-brake light is comong on when i start my veng (still 98 420a MtX) but after i drive bout 15-20? min. its goes off can anyone gimmie a clue what this would mean?...thanks in advance as always..
and no i dont have ABS...

 

check for level of brake fluid ... when it heatrs up it expands light goes out ...

 

im also have my anti brake light on and i know for a fact taht my abs isnt working because a dog jumped out infront of me and i locked em up... what can cause the abs to go out and how can i fix it.

 

ive broken abs sensors before... that atleast causes the light to go on. thay arent hard to brake either

 

ABS can be the sensors the computor or the modulator ....
They can run a scan and tell you what it might be ...

 

ok it was low(down to the bottom of the bracket) was hoping that wasnt it cuz i had to take strut bar off halfway to get my cap off...lol...so im thinking i prolly i have a leaky wheel cylinder(cheapest problem..)
i took it out last night and hammered on the brakes and only fronts locked up so ima go outside and jack up the rear a lil later and find out whats up witht he rear brakes i thought the braking was a lil subpar anywayz. ill let you guyz know whats going on..thnx again guyz..

 

brake fluid can and does boil off ... It might not be a leak .... just not checked in awhile ... it's normal for the fronts to lock up first ... since 75% of the braking is done there ...

 

...to add to that...as the pads wear down, the fluid follows. A set of low pads = a lower fluid level. It's a good idea to check the pads all the way around too.