ok i have just put in an amp in my 99avenger now this is my problem i cant find i hole in the fire wall to run my lines right now i have thim going threw the door jam and im afraid that will damage the cable does any one know where i can run it

 

The automatic venges have a triangular flat spot behind the drivers strut tower on the firewall and is easily drilled as it is singular layered and easy access to the battery

 

ok there is no hole there all ready there has to be one for all the wires to to run in or out or is drilling my only choice

 

The preexisting hole is tough to get anything thru as the space is very limited ... The rubber boot is above the brake pedal and a pain to pull anything thru ... The drill route is the best bet ...

 

ok then wounld you happen to have any helpful pictures on here this spot is ooo and another thing i have to change my brakes i know how but one of my friends said that i would need a tool to compress the rear plunger on the calaper is this true?and lastly my parking lights in the fron dont come on when i turn the head lights on what could be the problem you have been a big help and i thank you alot this is my first avenger i use to drive a neon but i think i am much happier now

 

http://img129.imageshack.us/img129/1512/strut4ga.jpg

I can't find a good picture if you lay in the footwell and look up you'll see the triangular area where the clutch cylinder would be mounted drill there

 

ok thanks alot for the help hey how do i get my motor to look like new it has that faded look and oil stains here and there and on the lights you have inside to light up the floor how many did you use i want to put some in mine but i want to light up the floor in the front and the back did you mount some under the dash and the seat or just the seat thanks alot

 

Cleaning the motor if it's really bad start with Gunk Foamy brite engine cleaner degreaser follow instructions , be sure to saran wrap electricals plug wires, cap ect ,Spray and let soak, Scrub the really dirty parts with a brush , hose down ... Also for still dirty areas I've used "Purple Power"

Lights I have a set of Cold Cathodes mounted under both seats one front , one rear,
under the dash I have a Piranha bar mounted under each side :
http://www.oznium.com/

 

ok one more question i have an air to fuel gauge now people are telling me it ties into the sensor but i don't know what wire it goes to its an apc gauge

 

Power and ground the third wire for the O2 sensor ... If you have the V6 it's on the PCM bottom connector White with black stripe towards the bottom near the middle