I have '95 chrysler cirrus with the 2.5 6g73 engine

Is there a throttle body mod? Is there a upper intake mod? Or any other mod that I could do? I have an exhaust setup and short ram intake
Give me a shout, my 2 cents

 

You can bore out the T/B to 59MM up to 60 if you nick the bearing You'll have to fab a new butterfly
You can port match the upper to lower manifold and extrude hone out the manifold

 

What would be the best way to bore out? Angle die grinder with a medium stone then polish with flitz. What is factory specs, 52mm bore out to;----> you said 60mm is maxium. I'm trying to acheive a better throttle response and passing movement.


5 x 100mm bolt pattern for the wheels, I'm also trying to find a better looking set of shoes than black steelies.

Thanks Bad Venge, you have a very nice ride

 

I did it on a milling machine with a boring bar then reversed the cutting tool to cut the butterfly to fit

port maching can be done by handgrinder with bits and then flap wheels