90 Window Replacement
Hall Of Fame
Joined: Aug 2007
Posts: 10,923
Likes: 19
From: NM
DOOR GLASS REMOVAL
- Remove the door trim panel (or, if applicable, the access panel), the waterdam and the noise insulator.
- Open the window glass (move the glass down into the door)
- Door Beltline Moulding Weatherstrip
- Remove the retaining screws and the beltline weatherstrip moulding from the door. CAUTION: Damage to the window glass rear track channel is possible it the glass is removed without using Tool C-4867 (or an equivalent tool).
- Use Tool C-4867 to disengage the window glass edge sliders from the glass rear track.
- Rotate the window glass on the regulator roller, slide it rearward and upward at a 45°angle, and remove it from the door.
- Install replacement edge sliders on the window glass rear edge.
- Insert the window glass into the door.
- Slide it forward and downward at a 45°angle.
- Engage the window glass edge sliders with the glass rear track.
- Engage the lift channel with the regulator roller.
- Position the beltline weatherstrip moulding on the door panel and install the retaining screws. Tighten the screws securely
- Install the noise insulator, the waterdam and the door trim panel (or, if applicable, the access panel).
Last edited by Crazy4x4RT; Oct 2, 2008 at 09:45 AM.
Thread Starter
|
Registered User
Joined: Sep 2008
Posts: 3
Likes: 0
the illustrations aren't even related to a door . The text is pretty close to what I'm dealing with . I'm going to drill out the rivits and take the bracket off in order to get it in the door. I think I will go ahead and pull the seals out of the track too.
